Table of Contents
Advertisement
Radiator Cooling Fan Removal and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Disconnect connector (1) of cooling fan motor.
1
3) Drain coolant.
4) Remove front bumper, front bumper upper absorber
and upper member referring to "Front Bumper and
Rear Bumper Components in Section 9K".
5) Remove radiator inlet hose and reservoir hose.
6) Remove cooling fan mounting bolts (1).
7) Slide condenser with radiator, and then remove
radiator cooling fan.
CAUTION
!
Be sure not to damage condenser outlet pipe.
Installation
Reverse removal procedure for installation noting the
following.
• Refill cooling system referring to Step 7) to 22) of
"Cooling System Flush and Refill".
• After installation, verify there is no coolant leakage at
each connection.
Radiator On-Vehicle Inspection and Cleaning
S7RS0B1606011
Inspection
Check radiator for leakage or damage. Straighten bent
fins, if any.
Cleaning
Clean frontal area of radiator cores.
I7RS0A160004-01
Radiator Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Drain A/T fluid.
3) Drain coolant.
4) Remove cooling fan assembly referring to "Radiator
Cooling Fan Removal and Installation".
5) Remove A/T fluid cooler inlet and outlet hoses.
6) Remove radiator outlet hose from radiator.
7) Remove radiator from vehicle.
Installation
Reverse removal procedures, noting the following.
• Refill cooling system referring to Step 7) to 22) of
"Cooling System Flush and Refill".
I4RS0A160009-01
• After installation, verify there is no coolant leakage
each connection.
• Refill A/T fluid referring to "A/T Fluid Change in
Section 5A".
Engine Cooling System:
S7RS0B1606012
I2RH01160014-01
S7RS0B1606013
1F-10
Hide quick links:
Advertisement
Chapters
Table of Contents
