Table of Contents
Advertisement
00-7 Precautions:
Warning for Wheel (with tire) Removal
WARNING
!
When removing any of these wheels installed
with wheel bolts, never remove all wheel
bolts at the same time. Leave at least 1 bolt
for each wheel as it is to prevent wheel from
dropping. When removing this remaining 1
bolt, hold wheel and tire so as not to allow
them to come off.
Warning for Handling Emergency Flat Tire
Repair Kit
WARNING
!
If vehicle is equipped with Emergency Flat
Tire Repair Kit instead of spare tire, be sure
to observe "Precaution for Emergency Flat
Tire Repair Kit in Section 2D" when handling
Emergency Flat Tire Repair Kit and repairing
flat tire.
Otherwise, your health may be ruined or it
will be impossible to repair flat tire.
Precautions for Catalytic Converter
For vehicles equipped with a catalytic converter, use
only unleaded gasoline and be careful not to let a large
amount of unburned gasoline enter the converter or it
can be damaged.
• Conduct a spark jump test only when necessary,
make it as short as possible, and do not open the
throttle.
• Conduct engine compression checks within the
shortest possible time.
• Avoid situations which can result in engine misfire
(e.g. starting the engine when the fuel tank is nearly
empty.)
Precautions for Installing Mobile
S7RS0B0000003
Communication Equipment
When installing mobile communication equipment such
as CB (Citizens-Band)-radio or cellular-telephone, be
sure to observe the following precautions.
Failure to follow cautions may adversely affect electronic
control system.
• Keep the antenna as far away as possible from the
vehicle's electronic control unit.
• Keep the antenna feeder more than 20 cm (7.9 in.)
away from electronic control unit and its wire
harnesses.
• Do not run the antenna feeder parallel with other wire
S7RS0B0000004
harnesses.
• Confirm that the antenna and feeder are correctly
adjusted.
Precaution for CAN Communication System
• The loose (1) in the wire harnesses twist of the CAN
lines except around the connector (3) should be within
100 mm (3.9 in.). Refer to the wiring diagram for the
CAN lines discrimination. Excessively-loosed lines
may be influenced by the electric noise.
S7RS0B0000005
• Do not connect terminals of the CAN line using a
bypass wire (1). Otherwise, the CAN line may be
influenced by the electric noise.
3
3
1
2
2
1
S7RS0B0000006
S7RS0B0000007
I4JA01000002-01
I4JA01000003-01
Hide quick links:
Advertisement
Chapters
Table of Contents
