Suzuki Swift Sport 2004 Service & Repair Manual page 224

1A-174 Engine General Information and Diagnosis:
DTC Confirmation Procedure
DTC P2227:
WARNING
!
• When performing a road test, select a place where there is no traffic or possibility of a traffic
accident and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out by 2 persons, a driver and a tester, on a level road.
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and warm up
engine to normal operating temperature.
3) Check DTC and pending DTC by using scan tool.
DTC P2228 / P2229:
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch, clear DTC by using scan tool and run engine for 1 min.
3) Check DTC.
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Is DTC P2227 set?
3 MAP sensor check
1) Check MAP sensor and its circuit referring to "DTC
P0107: Manifold Absolute Pressure / Barometric
Pressure Circuit Low Input" and/or "DTC P0108:
Manifold Absolute Pressure / Barometric Pressure
Circuit High Input".
Is check result satisfactory?
Action Yes
Go to Step 2.
Go to Step 3.
Substitute a known-
good ECM and recheck.
No
Go to "Engine and
Emission Control
System Check".
Substitute a known-
good ECM and recheck.
MAP sensor or its circuit
malfunction.