Dtc P0102: Mass Or Volume Air Flow Circuit Low Input - Suzuki Swift Sport 2004 Service & Repair Manual

Step
10 MAF sensor signal circuit check
1) Measure resistance between "GRN/BLK" wire terminal
of MAF and IAT sensor connector and "C37-26" terminal
of ECM connector.
Is resistance below 3
11 Is DTC P2135 detected?
12 Is DTC P0106 displayed?

DTC P0102: Mass or Volume Air Flow Circuit Low Input

Wiring Diagram
Refer to "DTC P0101: Mass or Volume Air Flow Circuit Range / Performance".
DTC Detecting Condition and Trouble Area
DTC detecting condition
MAF sensor output voltage is less than 0.15 V for 0.5
seconds continuously
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 10 sec.
4) Check DTC.
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1 Was "Engine and Emission Control System Check"
performed?
2 MAF sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Start engine and check MAF value displayed on scan
tool. (Refer to "Scan Tool Data" for normal value.)
Is normal value indicated?
Action
Ω
?
Action
Engine General Information and Diagnosis:
Yes
Faulty MAF and IAT
sensor.
Go to "DTC P2135:
Throttle / Pedal Position
Sensor / Switch "A"/"B"
(Main / Sub) Voltage
Correlation".
Go to "DTC P0106:
Manifold Absolute
Pressure / Barometric
Pressure Circuit Range
/ Performance".
Trouble area
• Open or short in MAF sensor circuit
• MAF sensor
• ECM
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
1A-61
No
"GRN/BLK" wire is open
or high resistance
circuit.
Go to Step 12.
Substitute a known-
good ECM and recheck.
S7RS0B1104018
No
Go to "Engine and
Emission Control
System Check".
Go to Step 3.