Dtc P0403: Exhaust Gas Recirculation Control Circuit - Suzuki Swift Sport 2004 Service & Repair Manual

1A-118 Engine General Information and Diagnosis:
Step
3 EGR valve operation check
1) With ignition switch turned OFF, install SUZUKI scan tool
to DTC.
2) Check EGR system referring to "EGR System Inspection
in Section 1B".
Is it in good condition?
4 MAP sensor check
1) Check MAP sensor for performance referring to "MAP
Sensor Inspection in Section 1C".
Is check result satisfactory?
5 EGR valve control circuit check
1) Check that EGR valve control circuits are in good
condition referring to Step 2 to 5 of "DTC P0403:
Exhaust Gas Recirculation Control Circuit"
Are circuits in good condition?
6 EGR valve check
1) Check EGR valve referring to "EGR Valve Inspection in
Section 1B".
Is check result satisfactory?
7 MAP sensor check
1) Check MAP sensor for performance referring to "MAP
Sensor Inspection in Section 1C".
Is check result satisfactory?

DTC P0403: Exhaust Gas Recirculation Control Circuit

Wiring Diagram
Refer to "DTC P0401 / P0402: Exhaust Gas Recirculation Flow Insufficient Detected / Excessive Detected".
DTC Detecting Condition and Trouble Area
DTC detecting condition
EGR valve output voltage is different from output command with more
than one pole out of 4 poles.
(1 driving cycle detection logic)
DTC Confirmation Procedure
WARNING
!
• When performing a road test, select a place where there is no traffic or possibility of a traffic
accident and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out by 2 persons, a driver and a tester, on a level road.
1) With ignition switch turned OFF, connect scan tool to DLC.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 30 seconds.
4) Check DTC.
Action Yes
Go to Step 4.
Intermittent trouble or
faulty ECM.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Go to Step 6.
Go to Step 7.
EGR passage clogged.
If OK, substitute a
known-good ECM and
recheck.
Trouble area
• EGR valve circuit open
• EGR valve
• ECM
No
Go to Step 5.
Replace MAP sensor.
Repair or replace EGR
valve control circuit(s).
Faulty EGR valve.
Replace MAP sensor.
S7RS0B1104045