Suzuki Swift Sport 2004 Service & Repair Manual page 321

5) Install cylinder head to cylinder block.
Apply engine oil to new cylinder head bolts and
tighten them gradually as follows.
a) Tighten cylinder head bolts ("1" – "10") to 20 N⋅m
(2.0 kgf-m, 14.5 lb-ft) according to numerical
order as shown by using a 12 corner socket
wrenches.
b) In the same manner as in Step a), tighten them
to 40 N⋅m (4.0 kgf-m, 29.0 lb-ft).
c) Turn all bolts 60° according to numerical order in
the figure.
d) Repeat Step c).
e) Tighten bolt "A" to specified torque.
NOTE
Be sure to tighten M8 bolt "A" after securing
the other bolts.
Tightening torque
Cylinder head bolt for M8 (a): 25 N·m (2.5
kgf-m, 18.0 lb-ft)
Cylinder head bolt for M10 (b): 20 N⋅m (2.0
kgf-m, 14.5 lb-ft), 40 N⋅m (4.0 kgf-m, 29.0 lb-ft)
and then retighten by turning through to 60°
twice
NOTE
• If they are reused, check thread diameters
of cylinder head bolt (1) for deformation
according to the follows and replace them
with new ones if thread diameter difference
exceeds limit.
• Measure each thread diameter of cylinder
head bolt (1) at "A" on 83.5 mm (2.81 in.)
from seat side of flange bolt and "B" on
115 mm (4.53 in.) from seat side of flange
bolt by using a micrometer (2).
Then calculate difference in diameters ("A"
– "B"). If it exceeds limit, replace with new
one.
Cylinder head bolt diameter measurement
points
"a": 83.5 mm (2.81 in.)
"b": 115 mm (4.53 in.)
Cylinder head bolt diameter difference
(deformation)
Limit ("A" – "B"): 0.1 mm (0.004 in.)
I2RH0B140091-01
6) Install camshafts, tappet and shim referring to
"Camshaft, Tappet and Shim Removal and
Installation".
7) Install timing chain referring to "Timing Chain and
Chain Tensioner Removal and Installation".
8) Install timing chain cover referring to "Timing Chain
Cover Removal and Installation".
9) Install cylinder head cover referring to "Cylinder
Head Cover Removal and Installation".
10) Install oil pan referring to "Oil Pan and Oil Pump
Strainer Removal and Installation in Section 1E".
Engine Mechanical:
1
"A"
"a"
"b"
2
1
1D-36
"B"
I2RH0B140092-01