Suzuki Swift Sport 2004 Service & Repair Manual page 247

Step
10 Main relay check
1) Check main relay referring to "Main Relay, Fuel Pump
Relay and Starting Motor Control Relay Inspection in
Section 1C".
Is main relay in good condition?
11 Sensor power source circuit check
1) Connect connectors to ECM with ignition switch turned
OFF.
2) Turn ON ignition switch, measure each voltage between
"C37-14", "E23-35", "E23-34" and "C37-43" terminals of
ECM connector and vehicle body ground.
Is each voltage 4 – 6 V?
12 Sensor power source circuit check
1) Disconnect connectors from ECM, TP sensor, APP
sensor, MAP sensor and A/C refrigerant pressure sensor
(if equipped with A/C) with ignition switch turned OFF.
2) Measure each resistance between "C37-14", "E23-35",
"E23-34" and "C37-43" terminals of ECM connector and
vehicle body ground.
Is each resistance infinity?
Action
Engine General Information and Diagnosis:
Yes
"BRN/WHT" wire is
open or high resistance
circuit.
ECM power and ground
circuit is in good
condition.
Check internal short
circuit of TP sensor,
APP sensor, MAP
sensor and/or A/C
refrigerant pressure
sensor (if equipped with
A/C).
1A-197
No
Replace main relay.
Go to Step 12.
"GRY/RED" wire is
shorted to ground
circuit.