Door Upper Seal Replacement - Acura 2002 RSX Service Manual

Doors
Door Upper Seal Replacement
NOTE:
. Take care not to scratch the door;
. Use a clip remover to remove the clips.
1. Remove these items:
' Power mirror, as necessary (see page 20-16)
. Door sash trim (see page 20-10)
2. Remove the door upper seal (A).
Installthe seal in the reverse order of removal, and
note these rtems:
. Make sure the upper seal is installed in the
h o l d e r ( B ) s e c u r e l y .
. Check for water leaks (see step 7 on page 20-13).
20-12
Door Glass Adjustment
NOTE:
. Check the weatherstrips and glass run channel for
damage or deterioration, and replace them if
necessary.
. Wipe the run channel clean with a shop towel.
. Lubricate the run channel with Shin-Etsu grease
PiN 98798 - 9013.
1. Place the vehicle on a firm, level surface.
2. Remove these items:
. Door panel (see page 20-4).
. Plastic cover isee page 20-2).
3. Caref ully move the glass (A) until you can see the
g l a s s m o u n t i n g b o l t s ( B ) , t h e n l o o s e n t h e m .
c A
l
r.l
.
,-,'-' ii-
..--' ir
_ =-1r
',
\
B
6 x 1 . 0 m m
9.8 N m {9.8 kgf.m, 7.2lbf.ft}
Push the glass against the channel (C), then tighten
the glass mounting bolts.
Check that the glass moves smoothly.
5 .