59. Apply a thin coat of multipurpose grease to the
i n s i d e o f t h e s o e c i a l t o o l . '
Install the cylinder end seal (A) onto the steering
rack (B)with its grooved side (C)toward the piston
(D). Make sure the gap is special tool is opposite of
rack teeth.
61. Separate the cylinde r end seal f rom the specia I tool,
then remove the special tool.
62. Installthe new backup ring (A) on the steering rack,
then place the backup ring and cylinder end seal (B)
against the piston (C).
63. Mark (A) a position on the steering rack surface
with a felt-tip marker, 14.5 mm (0.57 in.) from the
rack end edges.
14.2 mm (0.56 in.)
{cont'd)
17-47