ATF Temperature Sensor Test/Replacement
1. Removethe drain plug (A), and drain the automatic
transmission fluid (ATF).
15.0 kgf.m,36lbt.ftl
2. Reinstall the drain plug with a new sealing washer
( B ) .
3. Place the transmission jack under the transmission,
and lift it up to create clearance between the
transmission and front subframe.
4. Disconnect the shift solenoid harness connector.
5. Remove the bolt (A)securing the bracket (B) ofthe
ATF cooler inlet line (Cl on the shift solenoid valve
cover (D), and remove the line bolt (E) with sealing
washers (F).
21 tbf.ft)
6 x 1 . 0 m m
12 N.m (1.2 ksf.m,8.7 lbf ftl
6. Remove the shift solenoid valve cover, gasket (G),
and dowel pins (H).
(cont'd)
14-135