Acura 2002 RSX Service Manual page 674

Automatic Tra nsm ission
Transmission Removal (cont'dl
Remove the water pipe mounting bolt (A) and
lower the water pipe slightly. Loosen air cleaner
housing bracket mounting bolt (B), and remove
mounting bolt (C).
Remove the brake booster and EVAP line bracket
mounting bolts (D),and attach the special tool to the
threaded hole (E) in the cylinder heaq.
Install the engine suppon hanger (MR-T-12566) to
the vehicle and attach the hook to the soecial tool.
1 9 .
20.
14-142
21. Insert a 5 mm Allen wrench (A) in the top of the balj
joint pin (B), and remove the nut {C), then separate
t h e s t a b i l i z e r l i n k ( D ) f r o m t h e l o w e r a r m .
22. Remove the spring clips (E) and castle nuts (F), and
separate the lower arms (G) from the knuckles (H)
(see page 16-3).
23. Disconnect the A,/F sensor connector (A) and
secondary H02S connector (B), then remove the
harness from the clamps (C).