Acura 2002 RSX Service Manual page 746

Shafts and Clutches
Reverse Selector Hub,4th Gear Collar, and 3rd Gear Removal
Special Tool Bequired
Bearing separator OTKAF-pS30200
'02
Model: MRMA Transmission Number
1000001 -1021247
NOTE;
. Some reverse selector hubs,4th gear
collars, and 3rd
gears are not press-fitted, and can be removed
without using the special tool and a press.
. Place a shaft protector between
the countershaft and
a press to prevent damaging the countershaft.
'1.
Install the specialtool on the 4th gear (A). Set a
press on the countershaft (B) with putting a spacer
(C) between the press and countershaft, ind
remove the reverse selector hub (D).
14-214
2. Remove the needle bearing, then lnstallthe special
tool by inserting it into the opening betlveen the 3
r d g e a r a n d 4 t h g e a r c o l l e r ( A ) .
Set the press on the countershaft {B} with putting a
spacer between the press and countershaft, and
remove the collar.
Remove the set ring.
Set the press on the countershaft (A) with putting a
spacer (B) between the press and countershaft, and
remove the 3rd gear {C).
4.
5.
Remove the distance collar, Sth gear, 1st gear, and
2nd gear.