Acura 2002 RSX Service Manual page 974

9 .
8. Disconnect the cylinder switch connector (A). and
detach the harness clip (BL then remove the
cvlinder switch (C).
Remove the access cap (A). While holding the outer
handle (B) from the outside of the door, remove the
bolts. then remove the outer handle and outer
handle protector (C).
Fastener Locations
> : Boli, 2
@
6 x 1 . 0 m m
9.8 N m (1.0 kgf.m, 7.2 lbt.ft)
A
\
0
10. lnstallthe handle in the reverse order of removal,
and note these items:
. Make sure the cvlinder switch harness (A) is
routed ProPerlY.
. Make sure the cylinder switch connector is
plugged in properly, and each rod is connected
securely.
. Make sure the door locks and opens properly.
. When installing the lock cylinder, leavethe outer
door handle bolts loose so the anner protector
does not interfere with the lock cylinder
installation, then tighten the handle bolts.
. Install the lock cylinder retaining clip onthe
handle, then install the lock cylinder. Be sure the
clip is fullv seated in the slot on the lock cylinder'
. When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its perimeter.
20-7