Acura 2002 RSX Service Manual page 616

Automatic Tra nsm ission
DTC Troubleshooting (cont'd)
DTC P0745: Problem in Hydraulic Control
System of A"/T Clutch Preisure Control
Solenoid Valve A Circuit
NOTE: Record allfreeze data and review General
Troubleshooting lnformation (see page 14-3) before
you troubleshoot.
1. Check whetherthe OBD ll scan tool indicates
another code.
Does the OBD ll scan tool indicate another code?
YES Perform the troubleshooting flowchart for
the indicated code(s). Turn the ignition switch OFF,
and go to step 4 after troubleshooting.
NO-Go to step 2.
2. Turn the ignition switch OFF.
3. Replace the A,/T clutch pressure control solenoid
valve A (see page 14-130).
4. Reset the PCM memory by removing the No. 6 ECU
fuse (15A) in the under-hood fuse/relay box for
more than 10 seconds.
5. Start the engine, and shift to M position. Start the
vehicle off in 1st, drive at 19 mph (30 km/h) for 1O
seconds, shift to 2nd gear, drive at 19 mph
(30 km/h) for 10 seconds, then decelerate to a stop.
6. Repeat step 5.
7. Recheck for DTC P0745.
Does the OBD ll scan tool indicate code pO74S?
YES Replace the transmission assembly. t
NO-The problem has been corrected.l
14-84
b