Acura 2002 RSX Service Manual page 984

Mirror Holder Replacement
1 .
Carefully pull outthe bottom edge ofthe mirror
holder (A) by hand. Take care not to scratch the
m i r r o r .
p c A
Separate the mirror holder from the actuator (B) by
slowly pulling them apart while removing the
adhesive (C), detaching the clips (D), and releasing
the hooks (E). lf equipped, disconnect the mirror
defogger connectors from the heater pad terminals.
lf equipped, reconnect the mirror defogger
connectors.
Reattach the hooks of the mirror holder to the
actuator, then position the mirror holder on the
actuator. Carefully push on the clip portions of the
m i r r o r h o l d e r u n t i l t h e m i r r o r h o l d e r l o c k s i n t o
Dtace,
5. Check the operation of the actuator.
Rearview Mirror RePlacement
NOTE;When prying with a flat-tip screwdriver, wrap it
with protective tape to prevent damage.
1. Using a flat-tip screwdriver, caretully remove the
headliner cap (A) by releasing the hooks (B) Take
care not to scratch the cap and headliner (C).
Remove the screws, then remove the rearview
mirror (A).
Fastgnsr Locations
> : Scrsw,3
nn-rn
\:r-
3. lnstallthe mirror in the reverse order of removal.
) : - - -
- : - - ,
20-17