ABS Components
General Troubleshooting Information (cont'dl
4. Turn the ignition switch ON (ll) while continuing to
press the brake pedal.
5. After the ABS indicator goes off, release the brake
p e d a l .
6. After the ABS indicator comes on, press the brake
p e d a l a g a i n .
7. After the ABS indicator goes off, release the brake
p e d a l .
You cannot clear the DTC unless these conditions
are met:
. T h e v e h i c l e s p e e d i s 6 m p h ( 1 0 k m / h ) o r t e s s .
. The SCS circuit is shorted to body ground before
the ignition switch is turned ON (ll).
. The brake pedal is pressed before the ignition
switch is turned ON (ll).
19-34
8. After a few seconds. the ABS indicator blinks twice
and the DTC is cleared. lf the indicator does not
blink twice, repeat steps I thru 7. lf the ABS
indicator stays on after it blinks twice, check the
DTC, because a problem was detected during initial
diagnosis before shifting to DTC clearing mode.
9. Turn the ignition switch OFF.
'10.
Disconnect the Honda PG M Tester from the DLC.