Acura 2002 RSX Service Manual page 1441

)
1'1. Disconnect SRS unit connector A (18P) from the
SRS unit. Do not disconnect the special tool from
the floor wire harness 2P connector.
Check resistance between the No.7 and No. 18
terminals of SRS unit connector A (18P). There
s h o u l d b e 2 . 0 - ' 3 . 0 Q .
1 2 .
)
=,rt
SRS UNIT CONNECTOR
A (18P)
Wire side of female terminals
ls the resistance as s?ecitied?
YES - Faulty SRS unit or poor contact at SRS unit
connector A (18P) and the SRS unit. Check the
connection; if lhe connection is OK, replace the
SRS unit (see page 23-138).1
NO Open or increased resistance in the floorwire
harness; replace lhe floor wire harness.l
7
= - ,
,,,,[- Z;", i
-\=-ll^r.- l
23-95
DTC 12-3: Short to Another Wire or
Decreased Resistance in Front Passenger's
Side Airbag Inflator
Special Tools Requirod
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead E o7XAZ-S140200
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stav on?
YES Go to step 3.
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
3. Turn the ignition switch OFF Disconnectthe
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire hatness 2P connector (A)
from the front passenger's side airbag (B).
07xAz-s1A0200
Connect the special tool (2 Q connector) to the
floor wire harness 2P connector.
(cont'd)