Rear Seat-Back Pivot Bracket Replacement; Rear Seat-Back Striker Replacement - Acura 2002 RSX Service Manual

Rear Seat-back Pivot Bracket
1 .
Replacement
,{\p
/-
A
Remove the rear seat-back (see page 20-82).
Remove the pivot bolt (A), then remove the seat-
back pivot bracket (B). lf necessary. remove the
toothed lock washer (C), then separate the pivot
bolt, washer (D), bracket, and bushing (E).
5 x 1 . 0 m m
9.9 N.m
(1.0 kgl.m,7.2 lbf.ftl
3. Install the pivot bracket in the reverse order of
removal, and note these items:
. Apply multipurpose grease to the pivot portion of
t h e w a s h e r a n d b u s h i n g .
. Apply liquid thread lock to the pivot bolt before
reinstallation.
Rear Seat-back Striker Replacement
NOTE: Take care not to scratch the interior trim.
1 . R e m o v e t h e r e a r s i d e t r i m p a n e l ( s e e p a g e 2 0 - 5 0 ) .
2. Remove the bolts, then remove the seat-back
striker (A).
Fastener Locations
8 x 1.25 mm
22 N.m
(2.2 kgt.m, 16lbf.ftl
lnstall the striker ;n the reverse order of removal,
and move the striker (A) up or down until it is
centered in the seat-back latch (B).
> : Bolts,2
{,-l:
-rItl
\</
3 .
I
I
20-83