Acura 2002 RSX Service Manual page 1387

t
)
1 2 . D i s c o n n e c t S R S u n i t c o n n e c t o r C ( 1 8 P ) f r o m t h e
SRS unit. Do not disconnect the special tool from
the dashboard wire harness.
Check resistance between the No. 4 and No. 13
terminals and between the No. 5 and No. 14
terminals of SRS unit connector C (18P). There
s h o u l d b e 2 . 0 3 . 0 Q .
J
SRS UNIT CONNECTOR C I18P)
Wire side of female terminals
ls the resistance as specified?
YES Faulty SRS unit or poor contact at the SRS
unit connector c (18P). Check th e con nection; ifthe
connection is OK, replace the SRS unit (see page
23-138). t
NO--Open or increased resistance in the
dashboard wire harness; replace the dashboard
w i r e h a r n e s s . l
l . -
23-41
' t .
2.
DTC 2-3: Short to Another Wire or Decreased
Resistance in Front Passenger's
Airbag
lnflator
Special Tools Required
. SRS inflator simulator 07SM-TB401 1A
. SRS simulator lead F 07XAZ-S230100
Erase the DTC memory (see page 23-23).
Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SBS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the front passenger's airbag 4P
connector from the dashboard wire harness (A).
Connect the special tool (2 Q connectors) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
(cont'd)
6 .
1 .