Door Glass And Regulator - Acura 2002 RSX Service Manual

Doors
Door Glass and Regulator
Replacement (cont'd)
Installthe glass and regulator in the reverse order
of removal, and note these items:
. Roll the glass up and down to see if it moves
freely without binding.
. Make sure that there is no clearance between the
g l a s s a n d g l a s s r u n c h a n n e l w h e n t h e g l a s s i s
ctoseo.
. Adjust the position of the glass as necessary {see
page 2O-12).
. Check for water leaks (see step 7 on page 20-13).
. Test-drive and check for wind noise and rattles.
. When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its Derimeter.
20-10
Door Sash Trim Replacement
NOTE: Take care not to scratch the door.
1. Remove the power mirror, as necessary (see page
20-16), and slide the door glass outer weatherstrip
forward. as necessary (see page 20-1 1).
2. Pull back the door weatherstrip {A) atthe rear
upper corner, and remove the screw.
Adhesive tape: 3M 4211, or equivalent
Thickness 1.2 mm (0.047 in.l
Using a utility knife, carefully cut the double-faced
adhesive tape (B) at the bottom of the door sash
t r i m ( c ) .
Pull up the trim to release it from the clips (D). then
remove the trrm.
Install the trim in the reverse order of removal, and
note these items :
R e p l a c e a n y d a m a g e d c l i p s .
lf the old trim is to be reinstalled, scrape off the
remaining double-faced adhesive tape from the
trim, then clean trim surface with a sponge
dampened in alcohol where adhesive tape will be
applied. Glue the double-faced adhesive tape
(3M 4211, or equivalent) to the trirn
Before installing the trim, clean the door bonding
surface with a sponge damaged in alcohol.
Before installing the trim. peel the adhesive
backing from the double-faced adhesive tape.
After installing the trim, push the trim into place
securery.
Make sure the bottom pin (E) of the trim is
installed in the hole of the upper seal (F) securely.
5 .