Acura 2002 RSX Service Manual page 942

The blinking frequency indicates the DTC. DTCs are
indicated by a series of long and short blinks. One
l o n g b l i n k e q u a l s 1 0 s h o n b l i n k s . A d d t h e l o n g a n d
short blinks together to determine the DTC. After
determining the DTC, refer to the DTC
Troubleshooting Index.
NOTE:
. lf the DTc is not memorized, the ABS indicator
will go off for 3.6 seconds, and then come back
o n .
. lf the ABS indicator stays on,troubleshootfor
"ABS indicator does not go off" (see step 1 on
p a g e ' 1 9 - 5 5 ) .
The system will not indicate the DTC unless these
conditions are met:
. The brake pedal is not pressed.
. The ignition switch is turned ON (ll).
. The SCS circuit is shorted to body ground before
the ignition switch is turned ON (ll).
Example ot DTC 15
Long blink
Examole of DTC 22
Long blinks ltwo times)
Short blinks
(two times)
Turn the ignition switch OFF.
Disconnect the Honda PGM Tester from the DLC'
Short blinkt
(live timesl
How to Clear ABS DTCs
Honda PGM Tester Method:
1. With the ignition switch OFF, connect the Honda
PGM Tester (A) to the 16P data link connector (DLC)
(B) under the driver's side of the dashboard next to
the accelerator pedal,
A
2. Turn the ignition switch ON (ll), and clearthe
DTC(s) by following the screen prompts on the
PGM Tester.
NOTE: See the Honda PGM Tester user's manual
f or specif ic instructions.
Service Check Signal {SCS) Circuit Method:
1. With the ignition switch OFF, connect the Honda
PGM Tester (A) to the 16P data link connector (DLC)
(B) under the driver's side of the dashboard next to
the accelerator Pedal.
B
Short the SCS circuit to body ground using the
Honda PGM Tester.
Press the brake pedal.
(cont'd)
,f '-.\\
,' iji
, ' 1 , a
19-33