,l
DTC P0798: Problem in Ay'T Clutch Pressure
Control Solenoid Valve C Circuit
NOTE:
. Record all freeze data and review General
Troubleshooting Information (see page 14-3) before
you troubleshoot.
. This code is caused by an electricalcircuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Disconnect the A,/T clutch pressure control solenoid
valve C connector,
2. Measure A,/T clutch pressu re control solenoid valve
C resistance at the solenoid valve connector
t e r m i n a l s .
A/T CLUTCH PRESSURE CONTROL
SOLENOID VALVE C CONNECTOR
Jerminal side of male terminals
ls there 3- 10 Q?
YES-Go to step 3.
NO Replace the A,/T clutch pressure control
solenoid valve C.I
3 .
Disconnect PCM connectors B (24P)andC l22Pl.
Check for continuity between PCM connector
terminals 824 and body ground, and between C16
and body ground.
PCM CONNECTORS
Wire side of lemaleterminals
ls there continuity?
YES - Repair short to ground in the wires between
PCM connector terminals B24 and the Av/T clutch
pressure control solenoid valve C, and between
C 1 6 a n d t h e s o l e n o i d v a l v e C . l
NO- Go to step 5.
(cont'd)
B (2ilP)
c lzPl
14-103