Glass
1 2 .
Windshield Replacement (cont'd)
Glue the side rubber dams (A) and lower rubber
dam (B)with adhesive tape {NITTO 501. or
equivalent). Glue the fasteners (C) with adhesive
tape (3M 4215, or equivalent) to the inside face of
the windshield (D) as shown:
. Be surethe rubber dams and fasteners line up
with the alignment marks (E).
. Be careful not to touch the windshield where
a d h e s i v e w i l l b e a p p l i e d .
14.5 mm
(0.571 in.l
13.5 mm
20-22
13. Glue the molding (A) with adhesive tape (B)
(3M 4212, or equivalent) to the corner edge of the
windshield (C). Be careful not to touch the
windshield where adhesive will be aDDlied.
Install the fasteners to the body.
Fastener Locations
F : Fastener, 2
't 4.