Acura 2002 RSX Service Manual page 687

42. Connect the A/T clutch pressure control solenoid
valve A connector and 2nd clutch transmission
fluid oressure switch connector (B), and installthe
harness clamps {C) on the clamp brackets (D)'
lnstall the transmission ground terminal (E)'
Install the splash shield.
Installthe battery base, then installthe harness
clamp on the clamp bracket on the base
46. Refillthe transmission with ATF (see page 14-139)'
lnstall the intake air duct and air cleaner housing'
lnstall the battery tray and battery' then secure the
battery with its hold-down bracket.
49. Connect the battery positive terminal, then connect
the negative terminal.
50. Set the parking brake. Start the engine, and shift
the transmission through all gears three times'
51. Check the shift lever operation, A'lT gear position
indicator operation, and shift cable adjustment'
52. Check and adjust the front wheel alignment(see
p a g e 1 8 - 4 ) .
43.
44.
45.
4 7 .
48.
6 x 1 . 0 m m
9 . 8 N m
(1.0 kgt.m,
7.2tbl.ttl
53. Start the engine and let it idle until itreaches
normal operating temperature (the radiator {an
comes on) with the transmission in the E or E
position, then turn it off and check the ATF level
(see page 14-138).
5 4 . D o t h e P C M i d l e l e a r n p r o c e d u r e ( s e e p a g e 1 1 - 1 4 9 )
55. Do the power window control unit reset procedure
(see page 22-139)
56. Perform the road test (see page 14-120)'
57. Enter the radio station presets, and set the clock'
1 4- 15 5