1 1. Remove lhe valve body unit (A) from the steering
gearbox. Remove the O-rin0 {B) and discard it.
Remove the two boot bands (B) from boot A.
Compress boot A by hand, and apply vinyl tape (C)
so the boots stay collapsed and pulled back.
12.
1 4 .
13. Hold the gearbox housing using a C-clamp
(commercially available) (A) and the wooden
blocks (B) as shown. Do not clamp the cylinder
housing or gearbox housing in the vise.
Installthe special tool (A) on the lock screw (B),
then loosen and remove the lock screw from inside
of the gearbox housing (C).
07zAA-55A0'100
{cont'd)
17-39