Front Seat Cover Replacement 20-7 - Acura 2002 RSX Service Manual

Seats
Front Seat Cover Replacement
SRS comDonents are located in this area. Review the
SRS component locations (see page 23-10) and the
precautions and procedures (see page 23-11|,in the SRS
section before performing repairs or service.
NOTE:
. Take care not to tear the seams or damage the seat
covers.
. On the passenger's seat with side airbag, do not
touch the OPDS sensor in the seat-back pad. and keep
it away from oil. Oil can corrode the sensor causing it
to fa il.
. Put on gloves to protect your hands.
Seat-back Cover
1. Remove the front seat (see page 20-72).
2. From under the seat cushion, detach the side
airbag connector clip (A), and on the passenger's
seat, detach the OPDS unit connector clip (B)
Release the seat cushion cover (C) from the seat
cushion frame spring (D), then pullthe cover back,
and remove the harness bands (E). The passenger's
seat is shown, the driver's seat is symmetrical
except it has no OPDS unit connector.
20-76
Fold the seat-back forward.
lf equipped with a lumber support, remove the clip
{A), then remove the lumber support handle (B),
\
I'Y'
t t t t
6 / \ /
^-utuiL
Detach the hooks {A), then remove the front
headrest trim (B) and rear headrest trim (C). Pull
back the seat-back cover (D).