Acura 2002 RSX Service Manual page 966

ABS Modulator-Control Unit Removal and Installation
NOTE: '. "oo-not
,pirr brake f|uid on th-e Vehicle; it may damage the painu lf brake f|uid
gets on the paint, Wash it off
immediately wath water.
. Take care notto damage or deform the brake lines during removal and installation
. f o f r " u " n , , n " t r a k e f l - u i d f r o m f l o w i n g , p l u g a n d c o v e r t h e h o s e e n d s a n d i o i n t s w i t h a s h o p t o w e l o r e q u i v a l e n t
matenal.
Removal
1 . P u l l u p t h e l o c k ( B ) o f t h e A B S c o n t r o l u n i t 2 5 P c o n n e c t o r
( c ) , a n d t h e c o n n e c t o r d i s c o n n e c t s i t s e l f '
FLARE NUT
15 N.m (1.5 kgI m, 11 lbtft)
RUBBER MOUNT
MOUNTING BOLT
To right-front
To l€ft-rear
To right-rear
o left-front
mm NUT
9.8 N.m {1.0 kgf.m,7 2lbf ftl
B .
6 mm BOLT
9.8 N m (1.0 kgf.m, 7.2 lbf ftl
2. Disconnect the six brake lines
3. Remove the tl,/vo 6 mm nuts.
4. Remove the ABS modulator-control unit {A)
lnstallation
1. lnstall the ABS modulator-control unit, then tighten the two 6 mm nuts'
2. Reconnect the six brake lines, then tighten the nuts'
3. Align the connecting surface ofthe ABS control unit 25P connector'
4. push in the lock of the ABS control unit 25P connector until
you hear it click into place, then con nect the connector'
5. Bleed the brake system. starting with the front wheels
(see page 19-8)'
6. Start the engine, and check that the ABS indicator goes off
7. Test-drive the vehicle, and check that the ABS indicator does not come on'
19-57