Acura 2002 RSX Service Manual page 833

Power Steering
Pump Overhaul (cont'd)
Special Tools Required
. Attachment.32 x 35 mm 07746-00101OO
. Driver 07749-0010000
. Pulley holder 07ZAB-S5AOtO0
Disassembly
NOTE: Refer to the Exploded View as needed during the
following procedure.
1. Remove the power steering pump (see page 17_14).
2- Drain the fluid from the pump.
3. Hold the steering pump (A) a vise with soft jaws {B),
hold the pulley (C)with the speciat tool (D), and
remove the pulley nut (E) and pulley. Be careful not
to damage the pump housing with the jaws of the
vtse.
17-16
4 . R e m o v e t h e i n l e t j o i n t a n d O - r i n g .
5. Remove the flow control valvecap, O-ring, valve
spring, and pressure control valve.
6 . R e m o v e t h e p u m p h o u s i n g c a p , O - r i n g , a n d p u m p
preload spring.
7. Remove the pump cover and pump cover seals,
8 . P u l l o u t t h e r o l l p i n .
9. Remove the outer case, cam ring, roror. vanes, and
side plate.
1 0 . R e m o v e t h e r u b b e r s e a l a n d s l i p p e r s e a l f r o m t h e
outer case.
'11.
Remove the O-rings from the bottom of the
h o u s i n g .
Remove the snap ring, then remove the drive shaft
by tapping the shaft end with the plasUc nammer.
R e m o v e t h e s e a l f r o m t h e p u m p h o u s i n g .
t t .
lb
l