5. Install the control shaft (A) in the torque converter
housing aligning the manual valve lever pin (B) on
the control shaft with the guide of the manual valve
( C ) . P u l l t h e m a n u a l v a l v e g e n t l y w h e n a l i g n i n g t h e
manual valve with the control shaft.
Hook the detent arm spring (A) to the detent arm
( B ) .
6 .
7. Turn the shift fork shaft (A) so the large cha mfered
hole (B) is facing the fork bolt hole (C) of the shift
fork (D).
6 x 1 . 0 m m
1 4 N . m
(1.4 ksl m. 10lbl.ftl
ff)--'
rlt:
I
'.1
l-----^
-1
8. Installthe shift fork and reverse selector together
on the shift fork shaft and countershaft. Secure the
shift Jork to the shift fork shaft with the lock bolt
and a new lock washer (E), then bend the lock tab oJ
the lock washer against the bolt head.
9. lnstallthe needle bearing and countershaft reverse
gear on the countershaft.
10. Installthe reverse idler gear in the transmission
housing (see page 14-196).
11. lnstallthe idler gear shaft (see page 14'2251' it it
was removeo.
12. Install the three dowel pins and a new gasket on the
torque converter housing.
(cont'd )
14-245