Acura 2002 RSX Service Manual page 808

8. Adjust the length of the driveshafts to the figure
below, then adjust the boots to halfway between
full compression and full extension. Make sure the
ends of the boots seat in the grooves of the
driveshaft and ioint.
Left driveshaft:
K20A2 engine model:
502- 507 mm (19.8 20.0 in.)
K20A3 engine model:
503 508 mm {19.8-20.0 in.l
Right driveshaft:
K20A2 engine model:
/t8r ,$6 mm (18.9 19.1 in.)
K20A3 enqine model:
4 8 5 - 4 9 0 m m { 1 9 . 1 - 1 9 . 3 i n . l
9. Position the dvnamic damper as shown below.
Left driveshaft:
K20A2 engine model:
287 - 291 mm (1 1 .3 11.5 in.)
K20A3 engine model:
2 7 1 - 2 7 5 m m ( 1 0 . 7 1 0 . 8 i n . )
Right driveshaft:
271 275 mm (10.7 10.8 in')
Fit the boot (A) ends onto the driveshaft (B) and
outboard joint (C).
1 0 .
(cont'd)
1 6 - 1 5