Automatic Transmission
ATF Temperature Sensor Test/Replacement (cont'dl
7. Remove the bolt (A), and remove the shift solenoid
harness connector {B).
6 x 1 . 0 m m
12 N.m
{1.2 kgl.m, 8.7 lbt ft}
Measure ATF temperalure sensor resistance
between the No. 6 and No. 7 terminals of the shift
solenoid harness connector.
STANDARD: 50 0
25 k0
lf the resistance is out of standard, replace the ATF
temperature sensor with the solenoid harness. The
ATF temperature sensor js not available separately.
Disconnect the connectors from the shift solenoid
valves.
L
1 0 .
14 - 1 3 6
1 1 . Connect the shift solenoid valve D connector with
the ATF temperature sensor (F) on the new
s o l e n o i d h a r n e s s .
6 x 1 . 0 m m
12 N.m (1.2 ksf.m.8.7 tbf.ft)
12. Connect the solenoid valve A connector (BLU wire),
s o l e n o i d v a l v e B c o n n e c t o r ( O R N w i r e ) , s o l e n o i d
valve C connector (GRN wire), and solenoid valve E
c o n n e c t o r { R E D w i r e ) .
1 3 . I n s t a l l t h e n e w O - r i n g ( G ) o n t h e s h i f t s o l e n o j d
h a r n e s s c o n n e c t o r ( H ) , a n d i n s t a l l t h e c o n n e c t o r i n
t h e l r a n s m i s s i o n h o u s i n g .
14. Install the shift solenoid valve cover with the new
g a s k e t a n d d o w e l p i n s .
1 5 . I n s t a l l t h e A T F c o o l e r i n l e t l i n e w i t h t h e l i n e b o l t
a n d t h e n e w s e a l i n g w a s h e r s . C r e a t e c l e a r a n c e
with the jack between the transmission and the
front subframe to tighten the line bolt with the
r o r q u e w r e n c n .
1 6 . I n s t a l l t h e b r a c k e t o f t h e A T F c o o l e r i n l e t l i n e o n t h e
shift solenoid valve cover with the bolt.
17. Check the connector for rust, dirt, or oil, then
c o n n e c t t h e c o n n e c t o r s e c u r e l y .
18. Remove the transmission jack.
1 9 . R e f i l l t h e t r a n s m i s s i o n w i t h t h e r e c o m m e n d e d f l u i d
( s e e p a g e 1 4 - 1 3 9 ) .