Acura 2002 RSX Service Manual page 799

Driveline/Axle
Driveshafts Disassembly (cont'd)
Make a mark (A) on each roller (B) and inboard ioint
(Cl to identify the locations of rollers and groovls
in the inboard joint. Then remove the inboard joint
on the shop towel (D). Be careful not to drop the
rollers when separating them from the inboard
joint.
M a k e a m a r k ( A ) o n t h e r o l l e r s ( B ) a n d s p i d e r ( C ) t o
identify the locations of rollers on the soider, then
remove the rollers.
Remove the circlip (D).
Make a mark (E) on the spider (C) and driveshaft (F)
to identify the position of the spider on the shaft.
Remove the spider (C).
5 .
6.
7 .
16-6
ra
8. Wrap the splines on the driveshaft with vinyltape
(A)to prevent damage to the boot and dynamic
damoer.
Remove the inboard boot and dynamic damper. Be
careful not to damage the boot and dynamic
oamper.
Remove the vinyl tape.
1 0 .