Table of Contents
Advertisement
Automatic Transmission
DTC Troubleshooting (cont'dl
lMeasure the voltage between the No. 2 and No. 7
terminals of the transmission gear selection switch/
park pin switch connector (8p). and between the
N o . 8 a n d N o . 7 .
TRANSMISSION GEAR SELECTTON
SWITCH/PARK PIN SWITCH CONNECTOR t8PI
S-UP (WHT/BLUI
Wire side of female terminars
Are there about 5 V?
YES Go to srep 12.
NO-Go to step 9.
1 4 - 1 1 6
S.DN {BRN/WHTI
(BLKI
9 .
'10.
1 1 .
Turn the ignition switch OFF.
Disconnect PCM connector D { l7p}.
Check for continuity between pCM connecror
terminals D3 and body ground, and between D9
and body ground.
PCM CONNECTOR D (I7PI
S.DN (BRN/WHT)
Wire side of temate terminats
ls there continuity?
YES - Repair short to ground in the wtre oetween
PCM connector terminals D3 or Dg and the
transmission gear selection switch/park pin switch
connector (8P). t
NO-Go to step 12.
t
Advertisement
Chapters
Table of Contents
Troubleshooting
