Acura 2002 RSX Service Manual page 1390

sRs
DTC Troubleshooting (cont'd)
12. Disconnect SRS unit connector C (18P) from the
S R S u n i t .
Disconnect the special tool from the dashboard
wire harness 4P connector.
Reconnect the battery negative cable.
Turn the ignition switch ON (ll).
Check for voltage between the No. 4 terminal of
SRS unit connector C (18P) and body ground,
between the No. 13 terminal and body ground,
b e t w e e n t h e N o . 5 t e r m i n a l a n d b o d y g r o u n d , a n d
between the No. 14 terminal and body ground.
T h e r e s h o u l d b e 0 . 5 V o r l e s s .
SRS UNIT CONNECTOR C {18PI
1 4 .
1 5 .
t o .
Wire side of female terminals
ls the voltage as specitied?
YES Faulty SRS unit; replace the SRS unit (see
p a g e 2 3 - 1 3 8 ) . 1
NO Short to power in the dashboard wire
harness; replace the dashboard wire harness.l
23-44
DTC 2-5: Short to Ground in Front Passenger's
Airbag Inflator
SpecialTools Required
. SRS inflator simulator 07SM-T84011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO - intermittent failure. system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the front passenger's airbag 4P
connector from the dashboard wire harness (A).
Connect the special tool (2 Q connectors) to the
dashboard wire harness 4P connector.
4 .