Acura 2002 RSX Service Manual page 722

Transmission End Cover
Gontrol Shaft Bearing Replacement
Special Tools Required
. Driver 07749-0010000
. Attachment,22 x 24 mm 07746-0010800
1. Remove the oil sealfrom the end cover, then
remove the bearing.
I n s t a l l t h e n e w b e a r i n g f l u s h t o t h e e n d c o v e r w i t h
the soecial tools.
077ir9-0010000
2 .
0774d-oo1o8oo
\_-1,
i.-i,!r),it
3 . I n s t a l l t h e n e w o i l s e a l ( s e e p a g e 1 4 - 1 8 9 ) .
14-190
ATF Feed Pipe Replacement
1 . Remove the snap rings (A), ATF feed pipes (B), and
feed pipe flanges (C)from the end cover (D).
NOTE: Replace the end cover, if the 1st clutch ATF
feed pipe (E) replacement is required.
Install the new O-rings (F) over the ATF feed pipes.
lnstall the ATF feed pipes in the end cover by
aligning the feed pipe tabs with the indentations in
the end cover.
lnstall the new O-rings (G) in the end cover, then
install the feed pipe flanges over the ATF feed
prpes.
Secure the ATF feed pipes and feed pipe flanges
with the snap rings.
--c
op-)<-G
l - '
U\'
l-.