Automatic Transmission
Shift Gable Adjustment (cont'd)
Align the socket holder {A) on the shift cabte (B)
with the slot in the bracket base (C), then slide the
holder into the base. Install the shift cable end (D)
over the mounting stud {E) by aligning its square
hole {F) with the square fitting (G) at the bottom of
the stud, Rotate the holder a quarter rurn ro secure
the shift cable. Do not install the shift cable bv
twisting the shift cable guide (H).
Verify that the shift cable end (A) is property
installed on the mounting stud (B).
Prope y Installed:
1 0 .
lmprop€rly Installed:
/:=
::-\
ito-r :-
\r_.
:
_-/
rr------)----
-T---
t r l
t l
B
c_.-.-J
r-.--.-..-
------T---.1_l-
lJ]
Cable end rides on the bottom
of the mounting stud.
14-164
1 1. lf improperly installed, remove the shift cable from
the shift lever bracket base, and reinstall the shift
cable. Do not install the shift cable end on the
mounting stud while the shift cable is on the shift
lever bracket base.
12. Install and tighten the nut.
22 N rn l2.2 kgl.n.
16 tbt.ft)
Remove the 6.0 mm (0.24 in.) pin that was installed
to hold the shift lever.
fMove the shift lever to each position, and verify
that the A"/T gear position indicator follows the
transmission range switch.
Push the shift lock release, and verify that the shift
lever releases.
Reinstall the center console (see page 20-58).
1 3 .
1 4 .
1 5 .
1 6 .