Acura 2002 RSX Service Manual page 836

2 5 . I n s t a l l t h e o u t e r c a s e ( A ) b y a l i g n i n g t h e s l o t { B )
inside the outer case with the cover roll pin hole (C).
Be sure that the slit (D) on the outer case ls to
direction shown.
2 7 .
Apply the power steering fluid to the rubber seal (E)
(black), and install it in the slot (F) of the outer case.
Apply power steering fluid to the slipper seal (G)
(white), and install it on top ofthe rubber seal you
just installed.
26.
2 8 . I n s t a l l t h e c a m r i n g ( A ) b y a l i g n i n g t h e s l o t ( B ) w i t h
the slot (C) in the outer case.
lnsert the roll pin (D) into the slots between the cam
ring and outer case, then push roll pin into the set
h o l e ( E ) .
3 0 . I n s t a l l t h e r o t o r ( A f i n t h e c a m r i n g ( B )
3 1 . S e t t h e 1 1 v a n e s ( C ) i n t h e g r o o v e s i n t h e r o t o r .
l\ilake sure that the round ends (D) of the vanes are
in contact with the sliding surface of the cam ring.
n
[n
( c o n t ' d )
17-19