Acura 2002 RSX Service Manual page 650

Automatic Tra nsm ission
DTC Troubleshooting (cont,dl
DTC Pl717: Problem in ATp RVS Signal
Circuit of Transmission Range Switih-
NOTE:
. Record all freeze data and review
General
Troubleshooting Information (see page 14_3) before
you troubleshoot.
. This code is caused by an
electrical circuit oroblem
and cannot be caused by mechanical problem in the
transmission,
1. Check whether DTC p]705 or p1706 is indicated.
Does the OBD lt scan tool indicate code p1705 or
P 1 7 0 6 ?
YES Perform the troubleshooting flowchan for
the indicated code(s), then go to step 2.
NO Go to step 6.
2. Shift the shift lever into E position, and shift to
E,
l!!1, [O, then shift back to E, E, and into E. The shift
lever should stop for more than 2 seconds at each
position.
3. Turn the ignition switch OFF, then turn it ON fll).
4. Shift the shift lever to the E position for more than
2 seconds, then shift into m.
5. Check for DTC P1717.
Does the OBD
scan tool indicate code p 1717 ?
YES -' Go to step 6.
NO .The problem has been corrected.I
14-118
6.
1 .
Turn the ignition switch OFF.
Check for continuity between pCM connector
terminals 423 and body ground. and between 424
and body ground.
LG2 (8RN/YELI
PCM CONNECTOR A 131P)
1 2 t 3
4
5
6 1
LJ
8 9
0
t l
12
5 6
I 2A 21
LG1 (BRN/YEL)
o
r)
Wire side ot temale terminals
ls there continuity?
YES - Go to step 8.
NO Repair open in the wires between pCM
connector terminals A23 and ground (G 1O l), and
between A24 and ground (G101), and repair poor
g r o u n d ( G t 0 1 ) . I