Acura 2002 RSX Service Manual page 710

A/T lnterlock System
{
{
3.
4.
5 .
Reverse Lock System Circuit Troubleshooting
1. Check whether rhe DTC p1705 or p1706 is indicated.
Does the OBD ll scan toot indicate code p17OS or
P 1 7 0 6 ?
YES - Perform the Troubleshooting Flowchart for
the indicated Code{s).I
NO Go to step 2.
Turn the ignition switch OFF.
Shift the shift lever to the D position while pushing
the shift lock release.
Turn the ignition switch ON l).
Press the brake pedal and release the accelerator
pedal, shift the shift lever out of the E position, and
check that the shift lock solenoid operates.
Does the shift lever move out of theB position?
YES - Go to step 6.
NO Perform the Shift Lock System Circuit
Troubleshooting (see page 14-174)
6. Shift to the N position.
7. Turn the ignition switch to the ACC (l) position.
8. Check that the shift lever shifts into the E position.
Does the shift levet shitt into the@ position?
YES Checkfor loose terminal fit in the pCM and
multiplex control unit connectors. lf necessary,
substitute a known-good pCM and multiplex
control unit, and recheck,I
NO Go to step 9.
14-178
Turn the ignition switch OFF.
Remove the shift lock relay, and check for
continuity between these terminals:
. N o . 1 a n d N o . 3
. N o . 2 a n d N o . 5
. No. 4 and No. 5 while connecting battery voltage
to terminals No. 't and No. 3, and also check for
no continuity between terminals No. 2 and No. b.
SHIFT LOCK RELAY
Terminal side of male terminals
Does the shitt tock relay test OK?
Y E S - G o t o s t e p 1 1 .
NO - Replace the shift lock relay. t
1 1. Turn the ignition switch to the ACC {l) position.
9 .
1 0 .