Shift Solenoid Valves Test
'1. Remove the drain plug (A), and drain the automatic
transmission fluid (ATF).
2 . R e i n s t a l l t h e d r a i n p l u g w i t h
( B ) .
{5.0 kgf.m.36lbf.ftl
a new sealing washer
r.i '.
3. Place the transmission jack under the transmission,
and lift it up to create clearance between the
transmission and front subframe.
4. Disconnect the shift solenoid harness connector.
5. Remove the bolt (A) securing the bracket (B) ofthe
ATF cooler inlet line (C) on the shlft solenoid valve
cover (D), and remove the line bolt (E) with sealing
washers (F).
A
6 x 1 . 0 m m
12 N.m
6.
6 x l . 0 m m
12 N.m (1.2 kgf.m,8.7 lbt'ft)
Remove the shift solenoid valve cover, gasket (G).
a n d d o w e l p i n s ( H ) .
(cont'd)
{1.2 kgf.m,8.7 lbf.ftl
14-125