18. Installthe mainshaft speed sensor (Aland
countershaft speed sensor (B) with new o-rings (C).
6 x 1 . 0 m m
1 2 N . m
(1.2 kgt.m,8.7 lbf.ftl
6 x 1 . 0 m m
1 2 N m
(1.2 kgf.m,
8.7 tbf.ft)
19. lnstall the shift solenoid harness connector (F) in
the transmission housing with the new O-ring (G).
/J
6 x 1 , 0 m m
12 N.m
{1.2 kgf.m.
8.7 tbf.ft)
GRN
\
OFN
RED
20.
2 1 .
Connect the connector (YEL, WHT, and WHT wires)
to the shift solenoid valve D.
Connect the connectors to respective solenoid
vatves:
. BLU wire to shift solenoid valve A.
. ORN wire to shift solenoid valve B.
. GRN wire to shift solenoid valve C.
. RED wire to shift solenoid valve E.
'f
t,'-.\
22. Installthe shift solenoid valve cover (A)with the
two dowel Dins (B) and the new gasket (C), and
tighten the bolts (eight). lnstall the one bolt with the
bracketJorthe ATF cooler line in the bolt hole (D) in
step 33 in End Cover Installation (see step 34 on
page'14-253),.
14-247