Acura 2002 RSX Service Manual page 1032

Glove Box Removal/lnstallation
SRS components are located in this area. Review the
SRS component locations (see page 23-'10) and the
precautions and procedures (see page 23-1 1) in the SRS
section before performing repairs or service.
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove the passenger's dashboard lower cover'
2. While holding the glove box (A), remove the glove
box stop (B) on each side.
A
3 .
Remove the bolts, then remove the glove box.
Fastener Locations
> : Bott, 2
5 x 0 . 8 m m
5 N m
(0.5 kgf m,4lbf ft)
Install the glove box in the reverse order of
removal.
4 .
Driver's Side Vent Panel Removal/
lnstallation
NOTE:
. When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the
related Parts, to Prevent damage
. Take care noi to scratch the dashboard and related
pa rts.
1. Gently pry up on the driver's side vent panel {A) to
detach the clips (8, C), then pull out and remove it
Fastener Locations
B > : C l i p . 2
C > : C l i P , 2
2
\\;'
.€-
lf necessarv, remove the screws securing the
driver's side vent (A), then separate it from the
p a n e l ( B ) .
Fastengr Locations
> : Screw, 2
Installthe panel in the reverse order of removal,
and push the clip portions into place securely
20-65