Side Lmpact Sensor Replacement - Acura 2002 RSX Service Manual

Side lmpact Sensor RePlacement
Removal
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Disconnect the appropriate side airbag 2P
connector,
3. Remove the seat assembly (see page2O-721
4 . R e m o v e t h e r e a r s i d e t r i m p a n e l ( s e e p a g e 2 0 - 5 0 ) .
5. Disconnect the floor wire harness 2P connector
from the side impact sensor.
6. Remove the Torx bolt (A) using a Torx T30 bit, then
remove the side impact sensor (B).
s
)
lnstallation
1. lnstall the new side impact sensor with a new Torx
bolt (A) then connect the lloor wire harness 2P
connector (B) to the side impact sensor (C).
{1.0 kgt.m, 7.2 lbf ft)
Reconnect the battery negative cable
After installing the side impact sensor, confirm
proper system operation: Turn the ignition switch
ON (ll):the SRS indicator should come on for about
6 seconds and then go off.
Install all removed parts,
) - - , " \
N
A
23-139