Acura 2002 RSX Service Manual page 783

22. Set the control shaft(A)tothe.m position by
turning the control lever on the torque converter
s r d e .
NOTE: Do not squeeze the end of the control shaft
tips together when turning the shaft. lf the tips are
squeezed together it will cause a faulty signal or
position due to the play between the control shaft
and the switch.
f
N ( r t
Align the cutouts (A) on the rotary-frame with the
neutral positioning cutouts (B) on the transmission
range switch (C), then put a 2.0 mm (0.08 in )feeler
gauge blade {D) in the cutouts to hold the switch in
t h e E p o s i t i o n .
NorE: Be sure to use a 2 0 mm {0 08 in ) blade or
equivalent to hold the switch in the E position.
2 3 .
24. Install the transmission range switch (A) gently on
t h e c o n t r o l s h a f t { B ) w i t h h o l d i n g i t i n t h e N
oosition with the 2.0 mm (0.08 in.) blade (C).
25.
Tighten the bolts on the transmission range switch
w h i l e y o u c o n t i n u e t o h o l d i t i n t h e E p o s i t i o n D o
not move the transmission range switch when
tightening the bolts. Remove the feeler gauge.
6 x 1 . 0 m m
12 N.m 11.2 kgf m.8.7 lbf.lt)
(cont'd)
: : : - . ,
14-251