Acura 2002 RSX Service Manual page 782

Transmission End Cover
End Cover Installation (cont'dl
19. lnstallthe ATF feed pipe (A) into the idler gear shaft,
and install the ATF lubrication pipe {B) into the
transmission housing.
lnstall the end cover:
. '02 model (transmission number 1000001
1 0 0 6 1 6 6 )
-1 Install the new gasket (A) on the transmission
housing, and install the two dowel pins {B) and
new O-rings (C) over the top of the ATF feed
pipes.
- 2 l n s t a l l t h e e n d c o v e r ( D ) w i t h t h e 6 x 1 0 m m
bolts (15 bolts) and harness clamp bracket (E)'
6 x 1 . 0 m m
l2 N.m
t1.2 kgf m,8.7 lbl.ftl
20.
14-250
r J r
2' 1.
lnstallthe end cover:
. '02 model (transmission number 1006167 or
later). and'03 model
-1 Installthe new gasket (A) on the transmission
housing, and install the two dowel pins (B) and
new O rings (C) over the top of the ATF feed
pipes.
-2 lnstallthe end cover (D)' and tighten the three
special bolts (E) and the 6 x 1.0 mm bolts (12
bolts).
- 3 l n s t a l l t h e h a r n e s s c l a m p b r a c k e t ( F ) o n t h e e n d
cover.
E
28 N.m
(2.9 kgf.m,
21 tbf.ft)
6 x 1 . 0 m m
1 2 N . m
(1.2 kgf.m.
8.7 tbf.ftl
11.2 kqf.m,
8.7 rbf.ft)