Dtc Troubleshooting - Acura 2002 RSX Service Manual

SRS
DTC Troubleshooting
DTC 1-1: Open or Increased Resistance in
Driver's Airbag Inflator
Special Tools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON l), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SBS indicator stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures {see
page 23-23).
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 4P connector from
the cable reel {A).
07saz-TB40tlA
Connectthe special tool (2 Q connectors) to the
cable reel 4P connector,
23-32
I
6. Reconnectthe battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 1-1 indicated?
YES Go to step 9.
NO Open or increased resistance in the driver's
airbag inflator; replace the driver's airbag (see page
2 3 - 1 2 7 ) . a
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's airbag 4P
connector {A) from the dashboard wire harness.