Acura 2002 RSX Service Manual page 976

Door Glass and Regulator Replacement
NOTE: Put on gloves to protect your hands.
1. Remove these items:
. Door panel (see page 20-4)
. Plastic cover. as necessary (see page 20-2)
2. Carefully raise the glass (A) until you can see the
bolts, then remove them. Carefully pull the glass
out through the window slot. Take care not to drop
the glass inside the door.
Fastsnor Locations
) : Bolt. 2
6 x l . 0 m m
9.8 N.m (1.0 kgl.m,7.2 lbf.ftl
. . 4
3. Disconnect and detach the connector (A) and
harness clip (B) from the door.
Fartener Locations
C > : B o l t , 3 D ) : B o l t , 4
Remove the bolts (C), and loosen the bolts (D), then
remove the regulator (E)through the hole in the
ooor.
Apply multipurpose grease to all the sliding
surfaces of the regulator (A) where shown.
(cont'd)
6 x 1 . 0 m m
I N.m
(0.8 kgf.m,6lbf.ftl
20-9