Door Panel Removal/Installation - Acura 2002 RSX Service Manual

Doors
Door Panel Removal/lnstallation
Sp€cial Tools Required
Trim pad remover, Snap-on A 177A, cir equivalent,
c o m m e r c i a l l y a v a i l a b l e .
1. Remove the inner handle (A). Take care not to
scratch the door Danel,
-1 Pry out on the bottom portion of the cover
{B)
to release the clip {C) and tabs {D}, then remove
the cover.
-2 Remove the screws.
-3 Pull the inner handle out to release the hook (E).
-4 Pullthe inner handle forward and out half-wav
to release the hook (F).
-5 Disconnect the inner handle cable (G) and
power door lock switch connector (H).
Fastengr Locations
> : Screw, 2
2. Lower the glass fully.
20-4
3. Remove the screws from the armrest portion and
i n n e r h a n d l e o p e n i n g .
Fastener Locations
> : Screw, 3
Remove the switch panel (A). Take care nor ro
scratch the door panel.
-1 Pry out the front portion of the panel to release
the clips.
-2 Release the hooks (B) by pulling the panel
forward.
-3 Disconnect the power window swrtcn
connector (C).
Fastener Locations
) : Clip. 2
ilv!-
t5/