Rear Seat Belt Replacement - Acura 2002 RSX Service Manual

Seat Belts
Front Seat Belt Replacement
(cont'd)
6. Remove the center anchor bolt (A), and remove the
seat belt buckle (B).
7 . Pull the seat belt switch/tensioner harness (C) out
through the hole on the seat track.
Install the buckle in the reverse order of removal,
and note these items:
. Apply liquid thread lock to the center anchor bolt
before reinstallation.
. lf the seat belt tensioner has been deployed,
replace the front seat belt protector with a new
one.
. Apply liquid thread lock to the seat mounting
bolts before reinstallation.
. Reconnect the negative cable to the battery.
. Enter the anti-theft code for the radio, then enter
the customer's radio station oresets.
. Reset the clock.
. Do the ECM/PCM idle learn procedure (see page
1 1 - 1 4 9 ) .
8 .
7/16-20 UNF
32 N.m 13.3 kgf m, 2,1 lbf ftl
23-6
Rear Seat Belt Replacement
NOTE: Check the rear seat belts for damage, and
replace them if necessary. Be careful not to damage
them during removal and installation.
Rear Seat Belt
'1.
2 .
A
7/16-20 UNF
3 2 N m ( 3 , 3 k g f . m ,
24 tbt.ftl
3, Remove the upper anchor cap (A), and remove the
upper anchor bolt (B).
B
7/16-20 UNF
32 N.m 13.3 kgf.m,24lbl.ft)
Remove the rear side trim panel (see page 2O-50).
Remove the lower anchor bolt (A).
.b