Acura 2002 RSX Service Manual page 807

Hide thumbs Also See for 2002 RSX:

Table of Contents

Driveline/Axle

Driveshafts Reassembly (cont'd)

lnsert the driveshaft (A) into the outboard joint (B)

until the stop ring (C) is close to the ioint.

To completely seat the outboard joint, pick up the

driveshaft and joint, and drop them from about 1O

cm (4 in.) onto a hard surface. Do nor use a

hammer as excessive force may damage the

driveshaft. Be careful not to damage the threaded

section (A) of the outboard joint.

6. Check the alignment of the paint mark (A) with the

outboard joint end (B).

Pack the outboard joint {A) with the joint grease

included in the new joint boot set.

Grease quantity

Outboard ioint:

K20A2 engine model: 140 150 g (4.9-5.3 oz)

K20A3 engine modet: i05 tt5g{g.I -4.1ozl

Use the grease included in the

outboard boot set.

Chapters

Table of Contents